Industrial Automation
Motion Control & Drive Systems
The right drive, set up properly — for smoother processes, lower energy use and fewer trips.
- Genuine products only
- Engineer-led support
- Delivery across Pakistan
What’s included
- Drive selection & sizing
- Parameterization
- Retrofits
- Energy savings
- Fault diagnosis
- Soft starters
Why it matters
The outcome you can expect
Drives that trip for no clear reason, motors running at full speed when the process does not need it, and obsolete units with no spares — all of them cost production and power.
We size, supply, set up and retrofit drives so motors run the way the process needs.
Scope
What we deliver
- 01
Drive selection & sizing
VFDs and servo drives matched to the motor, the load and the environment.
- 02
Parameterization
Correct setup of ramps, limits, protection and communication for stable operation.
- 03
Retrofits
Replacing obsolete drives with current models, including wiring and control changes.
- 04
Energy savings
Speed control on pumps, fans and compressors where the process allows it.
- 05
Fault diagnosis
Finding the cause of trips and alarms — drive, motor, cable or process.
- 06
Soft starters
Reduced-voltage starting where full speed control is not needed.
How we work
From first visit to handover
- 01
Survey
We visit or review photos and drawings to understand the equipment, the problem and the goal.
- 02
Proposal
A clear scope, the parts required and an itemised quotation — with alternatives where they make sense.
- 03
Delivery
Genuine parts supplied and the work carried out by our engineers, scheduled around production.
- 04
Handover
Testing with your team, updated documentation and a walkthrough of what was done.
- 05
Support
Spares, troubleshooting and maintenance after handover, from the same team.
Brands
Brands we specify and supply
Genuine products, specified for your application and quoted with the service.
Industries
Where we apply it
FAQs
Frequently asked questions
Our drive keeps tripping. Can you find out why?
Yes. We read the fault history and check the drive settings, the motor, cabling and the load. Trips are often caused by settings or installation issues rather than a faulty drive.
Can you replace an obsolete drive with a different model?
Yes. We select a current drive with the right rating and features, adapt the wiring and control signals, and set it up to match or improve the old behaviour.
Will a VFD really reduce our electricity bill?
On pumps and fans that do not need full speed all the time, speed control usually reduces energy use. We look at how the equipment runs before recommending it, so you can judge the benefit.
Talk to an engineer
Discuss your motion control & drives project
Share a few details and an engineer will review them and get back to you with next steps.
Quotes within 24 hours on working days
Mon–Sat, 10:00 am – 8:00 pm